Лесопильные заводы - техника и оборудование - Импорт экспорт

Belmash factory presents two executions of the log splitters, one of them powered by electric induction motor LSE-500 and the other one equipped with gasoline engine LSG-500. The log splitter is equipped with 2 flywheels, capable of transferring huge energy to the push plate and the splitting force that is generated thereby can be compared to the force of a 20ton hydraulic press. The full cycle from start of the push plate till it’s moving back to starting position takes 1.5 seconds at most which allows to split a decent pile of logs in just a matter of minutes. As a safety measure, this log splitter has been designed to meet the so-called both hands use principal: in order to bring the splitting in action one needs to press the pushbutton and raise the lever simultaneously. To make the transportation of the machine easier, the log splitter is equipped with two pneumatic wheels as well as manual plastic handles.

Двухвальный бревнопильный станок «Триумф-СБЦ480» предназначен для распиловки бревен диаметром до 450 мм для получения лафета и бруса. Размер между пилами устанавливается при помощи проставок. Бревно устанавливается по центру стола и при помощи цепной передачи передвигается в зону пиления. Для регулировки скорости подачи станок оснащен частотным преобразователем позволяющим изменять скорость от 0 до 22 м/мин. В электрошкафу предусмотрен термостат для поддержания рабочей температуры. На станке предусмотрен выносной пульт управления в базовой комплектации. На станке «Триумф-СБЦ480» устанавливается до 8 пил на каждый вал двигателя. Общее количество пил до 16 штук.

The multi-blade two-shaft disc machine AKULA is used for sawing up 2, 3, 4 edge beams with a thickness of up to 210. 2-shaft technology has advantages over a single-shaft one. Using saws of smaller diameter, less cutting thickness, respectively, less waste, and most importantly more lumber yield! Benefits: Cutting height up to 210 mm. The ability to work 1 shaft, and installing it saws with a diameter of 450 mm, when installing saws with a diameter of 450 mm, the height of the cut with one shaft - 160 mm. Reinforced design, increased weight up to 3000 kg. Adjusting the height of the clamping ryabuh is performed simultaneously from one steering wheel, which speeds up the adjustment process. Increased set width. Increased amount of saws. Work in negative temperatures Easy operation The ideal geometry of the resulting lumber